Standards New Zealand :: Approval and test specification - General requirements for electrical equipment

Supersedes

NZS/AS 3100:1994

Publishing information

Status: SUPERSEDED

Published: No published date found.

Pages: 106

Committee: EL/02

References

This document may make references to other documents. All referenced documents are displayed below.

Standards NZ References:

AS/NZS 4695.2.2:1996
Fire hazard testing of electrotechnical products - Test methods - Needle-flame test
NZS/AS 1125:1993
Conductors in insulated electric cables and flexible cords
AS/NZS 4695.2.10:1996
Fire hazard testing of electrotechnical products - Test methods - Glow-wire test methods - General
AS/NZS 1020:1995
The control of undesirable static electricity
AS/NZS 4695.2.11:1996
Fire hazard testing of electrotechnical products - Test methods - Glow-wire end-product test and guidance
AS/NZS 4695.2.13:1996
Fire hazard testing of electrotechnical products - Test methods - Glow-wire ignitability test on materials
AS/NZS 4695.2.12:1996
Fire hazard testing of electrotechnical products - Test methods - Glow-wire flammability test on materials
AS/NZS 4695.112:1996
Fire hazard testing of electrotechnical products - Method for determining the comparative and the proof tracking indices of solid insulating materials under moist conditions

Overseas Standards References:

AS 1099.2 Basic environmental testing procedures for electrotechnology - Tests
AS 1931.2 High voltage test techniques - Part 2: Measuring systems
AS 1939 Degrees of protection provided by enclosures for electrical equipment (IP Code)
AS 1834.2 Material for soldering - Flux-cored solders
UL 94 Tests for flammability of plastic materials for parts in devices and appliances
AS 1099.1 Basic environmental testing procedures for electrotechnology - General
AS 1834.1 Material for soldering - Solder alloys
UL 746C Polymeric Materials - Use in Electrical Equipment Evaluations
AS 3000 Electrical installations - Buildings structures and premises (known as the SA Wiring Rules)
AS 1931.1 High voltage test techniques - Part 1: General definitions test requirements test procedures and
IEC 60252 A.C. motor capacitors
AS 1099.0 Basic environmental testing procedures for electrotechnology - Introduction and list of Parts of AS 1099 and I
AS 1099.2.63 Test Eg - Impact spring hammer
measuring devices
AS 2768 Electrical insulating materials - Evaluation and classification based on thermal endurance

ICS codes

International Classification for Standards (ICS) is an international classification system for technical standards. It is designed to cover every economic sector and virtually every activity of the humankind where technical standards may be used.

Follow these links to find other Standards similar to the one you are viewing.

AS/NZS 3100:1997

Approval and test specification - General requirements for electrical equipment

Table of contents

Buy product

Amendment history

Supersedes

Publishing information

References

ICS codes

AS/NZS 3100:1997

Approval and test specification - General requirements for electrical equipment

Table of contents

Buy product

Amendment history

Supersedes

Publishing information

References

ICS codes

Approval and test specification - General requirements for electrical equipment

Household and similar electrical appliances - Safety - Part 2.25: Particular requirements for microwave ovens including combination microwave ovens